realtek hd audio manager pops up everytime i plug in my headset

None of this happens with my speakers, I get no pop up messages, I don't get the option to configure them as 5.1 and even after I disconnect the cable from the optical output, it still shows as if the device is connected and enabled.

and I even get a pop up message saying a new device has been plugged in. Whenever I plug in my headphones through the front panel (Green) on my case, I get the option to configure my speakers in the Realtek HD Audio Manager for Stereo, quadraphonic, 5.1, etc. Checked to see if there was something muted, nothing was. Then I clicked on properties and disabled all enhancements.Ħ. I checked under Playback Devices to see if the Optical S-PDIF/out was enabled as default device, and everything was fine. Also I unchecked 'Mute the rear output device, when a front headphone plugged in'.ĥ. In Realtek HD Audio Manager, I checked 'Disable front panel jack detection', 'Make front and rear output devices playback two different audio streams simultaneously' and 'Separate all input jacks as independent input devices'. Check BIOS to see if audio settings were enabled, only option was HD Audio and it was enabled.Ĥ. Re-install drivers from MB's all-in-one CDĤ. Update Realtek HD Audio drivers to the latest one (6.)ģ.

This what I've done to solve the problem:ġ. Also the volume for my speakers seems to be off, at 100% I hear things as if I had my speakers at maybe 60-70% and I think the cause for this might be that I can't configure my speakers properly through Realtek HD Audio Manager to set it as 5.1 and maybe it is set as stereo by default. I'm having some issues with my Realtek HD Audio Manager where it doesn't recognize my speakers which are plugged through the S-PDIF/out (Green).

Realtek hd audio manager pops up everytime i plug in my headset